Finally a mount that is made correctly for your CR125 engine. The SwedeTech CR125 Engine mount offers the following features.
- Anodized 6061 T6 Aluminum Alloy Engine mount
- 7/10th's lb lighter than any other mount we have weighed
- Chassis clamps designed for either 1 bolt or 2 bolt per clamp option
- Chassis clamps serrated to minimize slippage
- Adjust the engine from left to right for proper clearance ( approximately 8mm, left to right )
- Engine Mount sits the rear of the engine up to 1" lower than other mounts
- Hardware securing engine to the mount is the proper sizes to match the Honda Cases
- Proper machining from front to back, engine will not be twisted when mounted to a straight frame.
- Proper radius on frame contact point
- Left side of rear engine mount machined to allow for chassis cross tubing weld clearance
- Lightening Holes through out the mount
- Stress Points taken into consideration during the design and machining process
This mount may cost a little more than some of the other mounts on the market. Buy the right mount the first time. Save money in the long run.
This is only a reference, for some chassis below. Contact your chassis Supplier for proper frame rail sizes.
CRG, GP, Zanardi, Maranello - 3290
Birel - 3292 or 3092
TonyKart, Kosmic, FA - 3092 or 3292
